Since i may have "squished" the nylon threads to fit, perhaps the nut is damaged and weak now? Just seems sketchy. But, im still quite worried that these could break off eventually and send me hurdling. The nuts fit tightly and i have to use my wrench to tighten them firmly just as i would with a regular lock nut setup. Im using nylon (regular/non-locking) hex nuts, 5/16 by 18 thread (rather than what im supposed to use by 24 thread) i read somewhere that since they are nylon you can tighten the 18thread nuts without ruining the trucks axle threads.Īnd it SEEMS like a good fix (i should mention that i am using needed washers between the wheel & truck as well). like, maybe grind down the bearing seat in the wheel with a drill press? Tried it, and the cutting disc i used was just too big at 22mm, and its hard to find ones that are 21mm.Īnyway! TLDR ive found something that might be a fix, but its still really sketchy. I use my skates for rhythm, mostly on outdoor surfaces and my skateboard wheels that arent fitting are my go-to's for that! Ever since getting this plate ive been racking my brain about how to get them to fit. Some wheels, (many of mine), dont fit tight enough on the arius due to the way it's trucks are shaped. So far, ive seen only like 2 or 3 other threads about this online. Hey there! Im in need of some help with my arius plates.
0 Comments
Leave a Reply. |